Everything for the beloved Dana 60 front axle. Save the searching and select from within this category for Ford, Dodge and GM Dana 60 parts.
Dana 60 Wheel Bearing and seal Kit. These are genuine Timken Wheel bearing sets. Do not settle for low quality bearings. Fits DRW (Dual Rear Wheel) or SRW (Single Rear Wheel) front hubs.
1 -Inner race
Kit Includes:Two 13" Vented RotorsLeft and Right Two Piston CalipersBrake PadsLeft and Right Caliper BracketsFour Caliper Bracket BoltsSixteen Wheel StudsONLY FITS CHEVY KINGPIN 8x6.5 APPLICATIONS!!!TECH NOTE:REQUIRES 16" WHEELS.MUST TURN HUB FLANGE TO:...
These brackets are for the GM Dana 60 ('77-'91) front king pin housing and Dodge Dana 60 ('90-'93) front king pin housing with internal hubs. They require no extra hardware, and are designed to use '73-'87 Chevy 3/4 ton 4x4 Calipers & Rotors (not...
Dana 60 Inner Axle seal, fits CUCV and GM D60. Also fits kingpin Ford Axles 2.625 OD
Genuine Dana Spicer
DANA SPICER 36487
Sold individually, order 2 per axle.
This is the Spindle Bearing and Seal kit for the GM and Dodge Kingpin Dana 60 front. Includes the bearing, inner seal, thrust washer and outer rubber seal.
Sold individually, Order 2 to do 1 axle.
Replacement Spindle for GM Dana 60 front. Fits all GM D60 kingpin front axles. Also fits Dodge D60 Kingpin front.
Replacement for spindle as part of P/N 700013L or Dana Spicer P/N 10086723
This is a NEW spindle...
Used Dana 60 Steering Arm. This is a stock GM piece, part number 38139
Will fit on GM, Dodge and Ford knuckles. Note that this is only a stock part for the GM axle. Confirm your application before ordering to be sure this will...
Breather vent cap. This one-way valve is used to cap breather hoses for axles and transfer case. Brand new! replaces GM P/N 8640496 Ships USPS.
Good used Dana 60 carrier from CUCV (GM Dana 60). Comes with 35 spline spider gears. 4.56 and up factory carrier.
Sorry, due to low supply, please contact us to order. We can also refurbish your hubs.
Ford DANA 60 SRW hub. Fits Ford 77.5 to 79 with 1/2" studs and up to 1998 with 9/16" studs. Fully refurbished with new rotor, studs, new...
Pair of DANA 60 Spindle/Hub dust shield. Welded assembly to replace the stock stamped seal, which are commonly rusted out, bent, or missing. Sold in pairs. Bare/Unpainted.
This kit includes U-bolts and plates to install your GM Dana 60 into your truck. These OEM GM Dana 60 plates have factory swaybar attachment points and have been sandblasted and painted for trouble free installation. The U-bolts are new and are 10" long,...